Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
LIGHTING INSTRUCTIONS
Do not attempt to light the grill if odor of gas is
present. Call for service 1-800-913-8999.
WARNING: IMPORTANT!
BEFORE LIGHTING…
these conditions exist call our customer service
line. If the flame is yellow, it indicates insufficien
t
air. If the flame is noisy and tends to lift away
from the burner, it indicates too much air.
TO MATCH LIGHT THE GRILL:
If the burner will not light after several attempts
then the burner can be match lit.
If you’ve just attempted to light the burner with
the igniter, allow 5 minutes for any accumulated
gas to dissipate. Keep your face and hands as
far away from the grill as possible. Insert a lit
extended match or lighter through the cooking
grids to the burner. Press the control knob and
rotate left to the HI setting, continue to press the
knob until the burner ignites. Burner should light
immediately. If the burner does not light in 4
seconds turn the knob off, wait 5 minutes and try
again.
TO LIGHT THE ROTISSERIE BURNER:
Open the lid; push the knob for about 5 seconds
without rotating. This will allow time for the gas to
flow into the rear burner. Continue pushing for 5
seconds then turn the knob to the HI position,
then press the igniter button to light the rotisserie
burner. If the burner does not light, turn the
control knob to “OFF”. If the igniter does not
function, follow the instruction above for match
lighting.
Inspect the gas supply hose prior to turning the
gas “ON”. If there is evidence of cuts, wear, o
r
abrasion, it must be replaced prior to use. Do no
t
use the grill if the odor of gas is present. Only the
pressure regulator and hose assembly supplied
with the unit should be used. Never substitute
regulators for those supplied with the grill. If a
replacement is necessary, contact the factory fo
r
proper replacement.
Screw the regulator (type QCC1) onto the tank.
Leak check the hose and regulator connections
with a soap and water solution before operating
the grill
TO LIGHT THE GRILL BURNER:
Make sure all knobs are “OFF” then turn on the
gas supply from the LP tank. Always keep you
r
face and body as far from the grill as possible
when lighting.
Your grill has an exclusive patented built-in
ignition. The igniter is built in to the valve. To
ignite each burner simply push and turn the
control knobs to the HI setting, you will hear the
valve click as it sends a spark to the pilot flame. I
f
the burner does not light, wait 5 minutes for any
excess gas to dissipate and then retry.
Flame Characteristics
Check for proper burner flame characteristics.
Each burner is adjusted prior to shipment;
however, variations in the local gas supply may
take minor adjustments necessary.
Burner flames should be blue and stable with no
yellow tips, excessive noise, or lifting. If any of
Keep a spray bottle of soapy water near the
gas supply valve and check the connections
before each use.
15