Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
20
W415-0484 / A / 07.26.06
PHAZER
TM
logs and glowing embers exclusive to Napoleon Fire-
places, provide a unique and realistic glowing effect that is
different in every installation. Take the time to carefully po-
sition the glowing embers for a maximum glowing effect.
Log colours
may vary. During the initial use of the fireplace,
the colours will become more uniform as colour pigments
burn in during the heat activated curing process.
1. Place the rear log against the locator, pushing down,
until it rests on the base, infront of the tabs.
2. Move the two small logs (#2 & #3) into position, lining
up the studs located on the burner with the holes on the
bottom of the logs. Ensure that the small logs sit flat on the
burner.
REARVIEW
LOCATOR
TAB
TAB
LOG PLACEMENT
Randomly place the charcoal embers along the front and
sides of the log support tray in a realistic manner. Fine dust
found in the bottom of the bag should not be used.
Tear the embers into pieces and place along the front row
of ports covering all of the burner area in front of the small
logs (#2 & #3). Care should be taken to shred the embers
into thin, small irregular pieces as only the exposed edges
of the fibre hairs will glow. The ember material will only
glow when exposed to direct flame; however, care should
be taken to not block the burner ports.
Blocked burner ports can cause an incorrect flame pattern,
carbon deposits and delayed ignition. PHAZER
TM
logs glow
when exposed to direct flame. Use only certified "glowing
embers" and PHAZER
TM
logs available from your Napo-
leon dealer.
Remove the backing of the
logo supplied and place on the
glass viewing door, as
indicated.
CHARCOAL EMBERS
GLOWING EMBERS
LOGO PLACEMENT
3. Place the bottom of the left crossover log (#4) onto the
locating stud on the left side of the log support.
The top of the log should rest in the pocket on the rear log.
4. Position the heel of log #5 into the slot in the centre of
the log support. ther end of the log rests in the pocket of the
left log.
5. Place the bottom of the right crossover log (#6) onto
the locating stud on the right side of the log support. The
top of the log should rest in the pocket provided on the
center log (#5).
FIGURE 37a-d
#1
#2 #3
#4
#5
#6
½"
½"
LOGO
FIGURE 38