Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
9
Problem Possible Causes Solution
Low heat / Low flame when
valve turned to high.
For propane - improper lighting
procedure.
Ensure lighting procedure is followed carefully. All gas grill
valves must be in the off position when the tank valve is
turned on. Turn tank on slowly to allow pressure to
equalize. See lighting instructions.
For natural gas - undersized
supply line.
Pipe must be sized according to installation code.
For both gases - improper
preheating.
Pre-heat grill with both main burners on high for 10 to 15
minutes.
Excessive flare-ups/uneven
heat.
Sear plates installed incorrectly.
Ensure sear plates are installed with the holes towards the
front, and the slots on the bottom. See assembly
instructions.
Improper pre-heating.
Pre-heat grill with both main burners on high for 10 to 15
minutes.
Excessive grease and ash build
up on sear plates and in drip
pan.
Clean sear plates and drip pan regularly. Do not line pan
with aluminum foil. Refer to cleaning instructions.
Burners burn with yellow
flame, accompanied by the
smell of gas.
Possible spider web or other
debris, or improper air shutter
adjustment.
Thoroughly clean burner by removing. See general
maintenance instructions. Open air shutter slightly
according to combustion air adjustment instructions.
Improper air shutter adjustment.
Close air shutter slightly according to combustion air
adjustment instructions.
Flames lift away from
burner, accompanied by the
smell of gas, and possibly
difficulties in lighting.
TROUBLESHOOTING
Normal occurence on hot days.
This is not a defect. It is caused by internal vibrations in the
regulator, and does not affect the performance or safety of
the gas grill. Humming regulators will not be replaced.
Burners will not crosslight
each other.
Plugged ports at back of burner.
Clean burner ports. See burner maintenance instructions.
"Paint" appears to be
peeling inside lid or hood.
Grease build up on inside
surfaces.
This is not a defect. The finish on the lid and hood is
stainless steel, and will not peel. The peeling is caused
by hardened grease, which dries into paint-like shards,
that will flake off. Regular cleaning will prevent this. See
cleaning instructions.
Regulator ‘Hums’ when
unit is operating.