Masterbuilt 20050412 Smoker User Manual


  Open as PDF
of 12
 
15
1
STEP 18
Hang matchstick (22) on side of
smoker body (1) as shown.
Assembly is complete!
Perform soapy water test to check
for gas leaks before use (see pg 3).
Note: Soapy Water Test MUST be
performed each time gas cylinder
is connected to burner/hose or
each time it is used.
22
ASSEMBLY
STEP 17
Slide drip cup (24) onto drip cup
bracket (30). Drip cup is needed to
collect grease run-off.
24
30
8
ASSEMBLY
STEP 4
Position burner box (6) over center
hole in bottom of smoker body,
carefully aligning venturi over valve
orifi ce as shown. Attach burner box
to smoker body using screws (A).
Firmly attach ignition wire to piezo
ignitor on control panel as shown
in Figure B.
A
6
Figure B
Venturi
Ignition Wire
Piezo Ignitor
Valve Orifi ce
Some parts not shown for
clarity.
STEP 3
Attach control panel (5) to right
front leg (25) as shown using
screws (A).
Repeat on opposite side attaching
contol panel (5) to left front leg (26).
25
26
5
A
 previous next