KitchenAid KFRS365T Gas Grill User Manual


 
27
OUTDOOR GRILL CARE
Replacing the Igniter Battery
If igniters stop sparking, the battery should be replaced.
1. Open battery compartment. Remove battery.
2. Replace with an alkaline 1.5 volt “D” size battery.
3. Close inner compartment, cover will snap into place.
4. Close outer cover.
Changing the Light Bulb
1. Unplug grill or disconnect power.
2. To remove glass light cover, remove screw and gently pry
downward with a small flat-blade screwdriver at the left edge
of the cover near the screw, and pull away from the retainer.
3. Remove bulb from socket.
4. Replace bulb with a new 12-volt, 10-watt maximum, halogen
bulb, using a tissue or wearing cotton gloves to handle the
bulb. Do not touch the bulb with bare fingers.
5. Replace glass light cover by placing end without clip into the
clip mounted on the grill. Snap the screw end into place and
tighten the screw.
6. Plug in grill or reconnect power.
General Cleaning
IMPORTANT: Before cleaning, make sure all controls are off and
the grill is cool. Always follow label instructions on cleaning
products.
For routine cleaning, wash with soap and water using a soft cloth
or sponge. Rinse with clean water and dry at once with a soft,
lint-free cloth to avoid spots and streaks.
Do not use steel wool to clean the grill, as it will scratch the
surface.
Use vinyl grill cover, available from your local dealer, to protect
finish from weather. See “Assistance or Service” section.
STAINLESS STEEL
IMPORTANT: Do not use soap-filled scouring pads, abrasive
cleaners, Cooktop Polishing Creme, steel wool, gritty wash
cloths or paper towels.
Cleaners should not contain chlorine. Damage may occur.
Food spills should be cleaned as soon as entire grill is cool. Spills
may cause permanent discoloration.
Cleaning Method:
Rub in direction of grain to avoid scratching or damaging the
surface.
KitchenAid
®
Stainless Steel Cleaner and Polish Part Number
4396920 (not included):
See “Assistance or Service” section to order.
Liquid detergent or all-purpose cleaner:
Rinse with clean water and dry with soft, lint-free cloth.
Vinegar to remove hard water spots.
Glass cleaner to remove fingerprints.
GRILL GRATES
IMPORTANT: Do not use a steel or fiber scraper on grill grates.
Immediately after you are finished cooking, loosen food soil with
a brass bristle brush. Turn all burners to HI for 10-15 minutes with
the hood closed to burn off food soil. Turn off all burners, raise
the hood and let grates cool. Use the brass bristle brush to
remove ash from the grill grates.
When completely cool, grill racks can be removed for thorough
cleaning. Clean them with a mild detergent and warm water.
For baked-on soil, prepare a solution of 1 cup (250 mL) ammonia
to 1 gal. (3.75 L) water. Soak grates for 20 minutes, then rinse
with water and dry completely.
A. Outer battery compartment cover
B. 1.5 volt “D” size battery
C. Inner battery compartment cover
A. Screw
+
-
A
B
C
A