KitchenAid KFRS361TSS Gas Grill User Manual


 
5
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
Parts Supplied
Gas pressure regulator/hose assembly set for 11" WCP LP
gas (attached to manifold)
Natural gas conversion kit with convertible regulator set for 4"
WCP Natural gas (on some models)
Natural gas conversion kit (on some models)
Rotisserie motor mounting bracket (on some models)
Rotisserie motor (on some models)
Rotisserie forks (on some models)
Rotisserie spit (on some models)
Smoker box (on some models)
2 warming drawer pans (on some models)
1 single-prong plug/500 mAmp transformer assembly for the
rotisserie motor (on some models)
2 - 1.5 V “D” size alkaline batteries (on some models)
Vinyl grill cover (on some models)
Parts Needed
20 lb LP gas fuel tank - approximately 18" (45.7 cm) height
and 12" (30.5 cm) diameter
UL outdoor-rated 120 V extension cord - size 14 gauge/3 wire
(marked 14/3 W-A), 50 foot (15.2 m) maximum length
Location Requirements
Select a location that provides minimum exposure to wind and
traffic paths. The location should be away from strong draft
areas.
Do not obstruct flow of combustion and ventilation air.
Clearance to combustible construction for freestanding outdoor
grills:
A minimum of 24" (58 cm) must be maintained between the
front of the grill hood, sides and back of the grill and any
combustible construction.
A 24" (58 cm) minimum clearance must also be maintained
below the cooking surface and any combustible construction.
Rotisserie
A 6" (15.2 cm) minimum clearance is needed for the rotisserie
motor.
A grounded, 3-prong outdoor outlet is located on the back of the
grill. See “Electrical Requirements” section.
NOTE: The rotisserie is an accessory on some models. See the
“Assistance or Service” section to order.
Tape measure
Small, flat-blade screwdriver
Flat-blade screwdriver
#2 and #3 Phillips screwdriver
Level
Short Phillips screwdriver or a
90° screwdriver with a Phillips
screw bit
Wrench or pliers
Pipe wrench
Scissors or cutting pliers
(to remove tiedowns)
Noncorrosive leak-
detection solution
WARNING
Explosion Hazard
Do not store fuel tank in a garage or indoors.
Do not store grill with fuel tank in a garage or indoors.
Failure to follow these instructions can result in death,
explosion, or fire.
WARNING
Fire Hazard
Do not use grill near combustible materials.
Do not store combustible materials near grill.
Doing so can result in death or fire.