Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
11
12
Inside of cart, connect the five wires from burner electrodes into the back of Electronic Ignition module,
Attach towel bar to right side extended shelf using two 1/4-20x1/2” screws, 7mm lock washers and 7mm
Note: Switch terminals are larger than electrode terminals and should only be installed in locations (a)
Connect the two wires [(a) and (b)] from switch wiring harness into the back of Electronic Ignition module,
(a)
(b)
Electronic ignition
+
-
Cap
AA battery
Left side panel
C
A
B
Nut
Electronic ignition
Tie wrap
Left side panel
module
NOTE: Wires omitted for clarity of illustration.
Remove the cap and nut from electronic ignition module. Attach electronic ignition module to the cart left
side panel with the nut, shown B.
Insert AA battery into ignition module, negative (-) end first. Then put on the cap, shown C.
1
2
3
4
5
module
Extended shelf
Towel bar
Right side fascia
screw
7mm lock
washer
7mm flat
washer
positions 1 - 5, shown A.
shown A.
and (b).
flat washers.
1/4-20x1/2” screw
1/4-20x1/2” screw
Qty.2
Qty.2
Qty.2
7mm lock washer
7mm flat washer
464224411 • 21