Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Assembling The LP Gas Tank Hook
Attach the Pressure Cylinder Holder and Tank
Guide to the Cart Legs-Wheel Side of grill as
shown in Fig. 6. Align the tapped holes of both
parts with the holes on Side Panel. Secure firmly
using 4 of the 1/4"x1/2" Phillips head screws and
nuts provided.
Assembling The Grill Pulled-out Spice Tray
1. Install 2 of the 1/4"x1/2" Phillips head screws
to the rear of the Track. Without these screws
the Pulled-out Spice Tray will not stop properly.
2. Slide the Pulled-out Spice Tray into the Tracks
until it stops. See Fig. 7.
.
Install 2 of the 1/4"xl/2" Phillips head screws
to the front of the Track. This important step
prevents the Pulled-out Spice Tray from being
pulled outside the tracks. See Fig. 7.
Figure 6
PULLED-OUT
SPICE TRAY
Figure 7
FOR PULLED-OUT
SPICE TRAY
PRESSURE
CYLINDER
HOLDER
TANK GUIDE
Installing The Grill Head
Now that you've assembled the grill cart you
can install the pre-assembled Grill Head. See
Fig. 8. To reduce the weight of the Grill
Head, we suggest you open the Grill Lid and
remove the packed components. Even with
the components removed, this step requires 2
people to lift and position the Grill Head onto
the grill cart. Be sure to align the 2 holes
beneath the hang ledge on each side of the
Grill Head with the 2 holes on each cross
brace of cart. Raise Grill Lid and insert 4 of
the 1/4"xl-3/8" Phillips head screws and lock
nuts and tighten securely.
2. From the back side of grill head, install the
Grease Draining Tray. See Fig. 8.
3. Center the Grease Receptacle under Grease
Draining Tray. See Fig. 8.
. Install Rear Wind Shield between both Bowl
Side Panels by using 2 of the 1/4"x1/2"
Phillips head screws provided. See drawing
below.
PULLED-OUT
SPICE TRAY
Figure 8
GRILL HEAD
2
I I
I !
I I
I
11
FOR PULLED-OUT
SPICE TRAY
GREASE GREASE
DRAINING RECEPTACLE
HANG LEDGE
CROSSBRACE