Kenmore 122.166489 Gas Grill User Manual


  Open as PDF
of 19
 
Installing Igniter Module
1. Remove silver battery cap and black hexagon plastic
nut from battery compartment of igniter module.
2. Position igniter module vertically so that battery
compartment is at the top of module.
3. Insert threaded stem of battery compartment through
hole in side burner control panel as shown (Fig. 10).
Tighten stem to panel using hexagon plastic nut.
Replace silver battery cap.
Assembling Left Side Shelf
• Remove two Phillips head screws and lock washers from
side shelf front panel, attach bottle opener and tighten
screws and lock washers.(Fig. 11,A)
• Remove (4) Phillips head screws and lock washers from
the back of the side shelf front panel and use them to
attach front panel to side shelf (Fig. 11,B).
• To attach left side shelf to grill, perform Steps 1 through 6
of Assembling Side Burner Shelf.
• Insert and tighten screw, washer and lock washer removed
in step 4 of Assembling Side Burner Shelf (Fig. 5, E).
• Remove Phillips head screw, washer and lock washer from
bezel at each end of towel bar, and use them to attach
towel bar and bezels to side shelf as shown (Fig. 12).
• Attach utensil hooks to side shelf as shown (Fig. 13, in next
page)
I hen you have finished assembling grill, make sure that all
screws and nuts are tight and secure.
Figure 7
@
Figure 9
Figure 10
Figure 11
A
5/64" hex wrench
B
Figure 12
Figure 8
B
\
A
8
 previous next