Jenn-Air CG205 Gas Grill User Manual


 
Cleaning Parts of
Your Cooktop
Control Bmobs
The knobs on the control panel can be removed with the controls in the OFF position.
Pull each knob straight from the shaft. Wash knobs in warm soapy water or dishwasher;
do not use abrasive cleansers or materials. To replace each knob, match flat part
of knob opening with the flat of the shaft, returning in OFF position.
IMPORTANT: Never use a metal blade to pry knob off. If knob cannot be easily removed,
tuck the folds of a cloth dishtowel under the knob skirt and pull the towel upward
with steady, even pressure.
Control Knob Area
Use mild cleansers, such as soapy water or mild liquid sprays, such as 409. Wipe
with sponge, damp cloth or paper towel. Do not scrub with S.O.S. pads or abrasive
cleansers.
Grill Grates
These are made from cast aluminum and are coated with the Excalibur® nonstick
finish.
After the grill gates have cooled, wipe off grates with a paper towel. Wash cool
grates (DO NOT IMMERSE HOT GRILL GRATES IN WATER) with soap or
detergent in hot water in the sink or wash them in the dishwasher. Be sure to
remove all food residue before cooking on the grill grates again.
Remove stubborn spots with a plastic mesh puff or pad. For best results, use
only those cleaning products which state they are recommended for use when
cleaning nonstick surfaces.
If grates were washed in the dishwasher, season with oil prior to grilling.
Do not use metal brushes or abrasive scouring pads or other scrubbers intended
to clean outdoor charcoal grills. These will remove the finish as well as scratch
the grates. Do not clean in the self-cleaning oven or use oven cleaners on the
grates.
GriH Burner
The grill burner should be cleaned after each use. It can be cleaned with a soapy
S.O.S. pad or in the dishwasher. Rinse and dry thoroughly before using again. For
heavy soil, burner should be cleaned first with a soapy S.O.S. pad, rinsed and dried.
Then it can be cleaned in a self-clean oven for 2 hours.
Note: Check to be sure all ports are open. To open clogged ports, insert a
toothpick directly into each port.
t
Surface Burner Assembly:
The surface burner assembly can be cleaned with mild detergents and a plastic scrubber
or washed in the dishwasher. To prevent scratching the burner heads, do not use
abrasive cleansers or scrubbing pads. Do NOT clean in a self-clean oven.
F
I Note; Check to be sure all ports are open. To open clogged ports, insert a I
LI toothpick directly into each port. 1
16