Hearth and Home Technologies GO30MTCH Outdoor Fireplace User Manual


  Open as PDF
of 20
 
Hearth & Home Technologies • Grand Oak Match Light Gas Log Sets • 4004-300 Rev C • 12/05
7
I. For Natural Gas Installation
• Pour sand into the burner pans to the point where the
burner pipe is covered. See Figure 3. Level the sand from
right to left to ensure an even fl ame pattern. At this point
the pan should be half full.
• Pour vermiculite over the sand in the pans until they are
full. See Figure 4.
Note: For best results, do not pack down the rock wool.
The placement of rock wool can have an effect on fl ame
pattern and may need to be adjusted to achieve a desired
appearance.
Fire Risk
Explosion Risk
Personal Injury Risk
Failure to position the parts in accordance
with the diagrams provided with the log
packages or failure to use only parts
approved with this appliance may result in
property damage or personal injury.
WARNING
Figure 4 Placing Vermiculite
Figure 3 Sand
Figure 5 Placing Rock Wool
• Lightly place dime-size pieces of rock wool evenly on top
of the sand and vermiculite to achieve a glowing ember
effect. See Figure 5.
• Remove the Platinum Bright Embers™ from the package.
For optimum performance peel each piece apart in layers
and lightly place on top of the vermiculite and rock wool
where the fl ame is blue. This will achieve the desired
realism.
• The gas burns at the point of the least resistance. In
case of an uneven fl ame pattern it may be necessary to
adjust the materials in the pans (using an object such as
a screwdriver) to achieve the desired effect.
• Place desired amount of lava granules on the fl oor of the
fi replace. DO NOT ALLOW THE GRANULES TO COME
IN CONTACT WITH THE FLAMES. (Lava granules may
contain moisture which, when heating, may cause it to pop
out during installation and set-up.) Ensure the controls
and switches are unobstructed after the granules are
installed.
• Place logs. See Sections L and N.
• Place accent logs around burner on fl oor of fi replace.
 previous next