Grizzly T24631 Grill Accessory User Manual


  Open as PDF
of 6
 



     
Figure 9.
       

       
       
   
     
       

20.       

21.       
 

       

22. 
        


        

Installing or adjusting a carbide cutter:
1. 
2.        

3. 
4.        
    
       

Note: Proper cleaning is critical to achieving
a smooth finish. Dirt or dust trapped between
the insert and cutterhead will slightly raise the
insert, and make noticeable marks on your
workpieces the next time you cut.
5.       
      
   

Note:Excess oil may squeeze between the
insert and cutterhead or in the screw hole,
thereby lifting the insert or screw slightly and
affecting workpiece finishes.
Figure 10.


Rotating Inserts



      
        
Figure 10
Straightedge
Outfeed Infeed
Figure 9. 
Figure 8.
Top Dead
Center
Bottom Dead
Center
19.       
 


Figures 8 & 9
 previous next