Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Figure 3. Steps
1– 4
Figure 4.
5.
Figure 4
6.
Figure 5
Note: Your cutterhead may have paper shims
stuck to the bearing block or where the bear-
ing block rests. These were included at the
factory when they calibrated your cutterhead
to be even with the outfeed table. Your new
cutterhead may or may not need these. If
you see any shims, carefully pull them off
and set them aside for later use—or keep
them with your cutterhead in the event that
you Re-install it later. Also, mark the side of
the cutterhead where they were used, so the
future install will go smoothly.
7.
8.
Page
5
Installation
1.
2.
3.
4.
Figure 3
Note: When lowering, make sure that the
fence support does not come in contact with
the cutterhead pulley.
Figure 5.