Grizzly T24631 Grill Accessory User Manual


  Open as PDF
of 6
 


16.        

      
     


       

Step 19
       
Step 17
17.       



Note:Use the shims from your old cutterhead
if available. If not available, newspaper is
approximately 0.003" thick and will work for
shimming (we don't recommend shimming
more than 0.004" on either side, as this may
affect how the bearing block seats in the cast-
ing).
18. Steps 15–17


Straightedge
Outfeed Table
Figure 7. 
14.       

Figure 6. 
15. 
     
Figure 7
      
      
   

9.      
     
 


     

Note: It is difficult to remove the bearings
without damaging them. This is why we
strongly recommend installing new bearings
on the cutterhead—instead of trying to reuse
the original ones and then repeating this pro-
cedure again in the near future.
10.       
 
     



      

        

11. 

12.       

13. Figure 6

 previous next