Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
76
Assembly Instructions
Unpack your GIPOD200 and check that all the parts are present.
(See fig. 1)
Before first use wash the base, grill, drip tray and lid in warm soapy water.
Rinse and dry thoroughly . DO NOT IMMERSE THE TEMPERATURE CON-
TROL PROBE IN WATER.
1. Secure the bottom ring onto the bottom of the Audio Stand (See fig. 2)
with the 6 screws supplied.
2. Place the Audio stand on a flat level surface.
3. Place the iPod® MP3 holder in position over the opening in the top of
the Audio Stand . (See fig 5).
4. Insert the connecting tube into the hole in the center of the Audio Stand
and rotate clockwise to secure.
5. Place the Grill Base on the top of the connecting tube and rotate slightly
so that the tabs on the connecting post align with the slots in the grill
base. Lift the locking latch up so it mates with the locking ring on the
bottom of the Grill Base. (See fig 3).
6. Place the Drip tray securely into the Grill base.
7. Position the Grill Plate onto the base so that the Opening for the
temperature control Probe fits through the opening in the Grill Base
(back right.)
8. Secure the Lid onto the Grill Plate by first matching the “L” and “R”
symbol of the lid to the “L” and “R” symbol on the Grill Base. Then
pressing the hinge pins down into the recess of the Grill Plate.
9. To close the lid completely pull forward on the front handle of the lid.
(See fig 4)
1
2
11
12
10
3
5
8
9
4
6
7
Getting To Know Your GIPOD200
1. Bottom Ring
(p/n 22835 - 1 section)
2. Audio Stand (p/n 22836)
3. Connecting Tube (p/n 22837)
4. iPOD® MP3 Holder (p/n 22838)
5. Drip Tray (p/n 22839)
6. Grill Base (p/n 22840)
7. Temperature Control Probe
(p/n 21006A)
8. Grill Plate (p/n 22842)
9. Lid (p/n 22843)
10. Audio Stand Power Supply Cord
11. Screw Package (p/n 22844)
12. Audio Cable (p/n 22845)
Fig. 1
Fig. 2 Fig. 3
GR_GIPOD200_IB_5-12-06 12/7/06 2:14 PM Page 11