GE Monogram ZGG420LBPSS Gas Grill User Manual


  Open as PDF
of 36
 
Lighting Using the Control Knob
WARNING:
• Always open the hood prior to lighting.
• Always keep your face and body as far away
from the grill as possible when lighting.
Open the hood, push and turn the grill control
knob to the LITE position and hold. You will hear
a snapping sound, which is the igniter sparking.
Once lit, turn the control knob to the desired
setting.
If the burner does not light
in 4 seconds, turn the knob
to OFF and wait 5 minutes
for any accumulated gas
to dissipate before trying
again.
NOTE: All igniters spark
simultaneously when
pressing in any burner
control knob.
IMPORTANT: The grill may smoke for a few
minutes the first time it is used due to factory
process oils. Run one complete pre-heat cycle
(15 minutes with main burners on HIGH) with
the hood down. Separately, run the Infrared
Sear Burner (if equipped) for 10 minutes
on HIGH to assure all oils are burned off.
13
To light
the grill
Lighting Using a Match
WARNING:
• Always keep your face and body as far away
from the grill as possible when lighting.
A match stick extension rod is provided inside
the grill drip tray. To match light a main grill
burner, insert the UNLIT match stick securely
into the clip end of the extension rod. Light the
match stick and, holding the end of the rod, pass
the flame of the lit match through the grill grate,
past the heat diffuser directly in front of a burner
port. Push and turn the control knob, which is
centered on the burner you are trying to light,
to the LITE position. Once lit, turn the control
knob to the desired setting.
Wait 5 minutes before attempting to relight
a burner.
If the burner did not light in 4 seconds,
turn all control knobs to OFF, leave the hood
open to allow any accumulated gas to dissipate
and wait 5 minutes before trying to light it again.
If the burner will not light after several attempts,
see the Problem Solver in the back of this
manual.
Grill control knob
 previous next