FMI (V)3612ST Outdoor Fireplace User Manual


 
www.fmiproducts.com
115603-01D14
OPERATION AND MAINTENANCE GUIDELINES
Continued
ways open mechanism when starting a re.
This provides adequate outside combustion
air. Close mechanism when not in use to
prevent cold air from entering room. Periodi-
cally check your outside air intake vent hood
for any possible obstructions such as snow,
bushes, etc.

The grate is designed to provide you with the
maximum solid fuel capacity. Do not overload
grate or obstruct required air space beneath
it. Doing so may cause smoke spillage and
a re hazard.
-


grate has been designed to keep
    

Never obstruct ow of combustion and ven-
tilation air. Keep front of replace clear of all
obstacles and materials.

Have your chimney system cleaned and in-
spected regularly to ensure safe and efcient
operation.

The damper control lever is located inside the
re chamber (see Figure 32). Make sure lever
is cool before handling. Pull down to close and
push up to open. Damper must be open when
lighting a re. Not doing so will cause smoke
spillage into the room. When replace is not
in use, close damper to prevent down drafts
to enter room.
GRATE
OUTSIDE AIR
HANDLE
PULL TO CLOSE
PUSH TO OPEN
DAMPER CONTROL LEVER
PULL DOWN TO CLOSE
PUSH UP TO OPEN
Figure 32 - Damper Operation

The outside air handle is located at the right
hand side of replace rear refractory (see
Figure 32). Pull to close, push to open. Al-
TECHNICAL SERVICE
You may have further questions about instal-
lation, operation, or troubleshooting. If so,
contact FMI PRODUCTS, LLC at 1-866-328-
4537. When calling please have your model
and serial numbers of your heater ready.
You can also visit our web site at
www.fmiproducts.com.