Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Using the Rotisserie & Side Burners
16
ROTISSERIE LIGHTING
Open the lid. Push and turn the control knob for the
rotisserie counter clockwise to the “HIGH” position. Wait
5 seconds. Then press and hold the electronic igniter
button. You’ll hear a snapping sound. If the burner
does not light in 4 seconds, turn the control knob to
OFF and wait 5 minutes before trying again. Once lit,
turn the control knob to the desired setting. (See Fig.
19)
MATCH LIGHTING
If by chance the electronic igniter does not light the
burner, the burner may be lit with a match. Attach the
match to the match extender, located inside the right
cart door.
Keep your face as far away from the grill surface as possi-
ble and hold a match, attached to the match extender, to
the burner, then push and turn the control knob counter
clockwise to the “HIGH” position. (See Fig. 20)
NOTE: After the first use the stainless steel
around the burner will darken. This is a normal
reaction of premium stainless steel to heat and is
not a defect. The infrared panel will also darken
after initial use. This is also a normal occurrence.
SIDE BURNER LIGHTING
Push and turn the control knob to the “HIGH” position
and immediately press and hold the electronic igniter
button. You’ll hear a snapping sound. It may be nec-
essary to hold the electronic starter button for about 4
seconds. If the burner does not light in 4 seconds,
turn the knob to the “OFF” position and wait 5 minutes
before trying again. Repeat above steps to light
remaining burners. (See Fig. 21)
MATCH LIGHTING
If by chance the electronic igniter does not light the
burner, the burner may be lit with a match. Attach the
match to the match extender, located inside the right
cart door.
Keep your face as far away from the grill surface as
possible and hold a match, attached to the match
extender, near the burner ports
, then push and turn the
control knob counter clockwise to the “HIGH” position.
Fig. 19
Fig. 20
Fig. 21
NOTE: Do not operate the main
burners and infrared back burner
at the same time. This can cause
warping of the roll top grill hood.
!