Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
28 www.ducane.com
NORMAL OPERATION
MAIN BURNER IGNITION
Summary lighting instructions are inside the cabinet door.
m DANGER: Failure to open the lid while igniting the
barbecue’s burners, or not waiting five minutes to allow the
gas to clear if the barbecue does not light, may result in an
explosive flare-up which can cause serious bodily injury or
death.
A) Open the lid (1) and make sure that all burners are in the OFF position (2).
B) Turn the cylinder on by slowly turning the cylinder valve counterclockwise (3).
m WARNING: The burner control knobs must be in the OFF
positionbeforeturningontheLPcylindervalve(3).If
they are not in the OFF position, when you turn on the LP
cylinder valve, the “excess gas flow control” feature will
activate, limiting the flow of gas from the LP cylinder. If this
should occur, turn OFF the LP cylinder valve and burner
control knobs. Start over.
m DANGER: When the “excess gas flow control” feature
is activated, a small amount of gas is still flowing to the
burners. After turning off the LP cylinder valve and burner
control knobs, wait at least five minutes for the gas to clear
before attempting to light the grill. Failure to do so may
result in an explosive flare-up, which can cause serious
bodily injury or death.
Electronic Ignition System
Each control knob operates an individual burner, and each burner ignites with an
electronic igniter. The electronic ignition system ignites each burner individually with a
sparkfromtheigniterelectrodeinsidetheignitionbox.Yougeneratetheenergyforthe
sparkbypushingtheelectronicignitionbutton.Youwillhearitclicking.
C) Ignite the burners individually from left to right. Begin with the burner on the left (4);
push control knob in and turn it to HIGH. Push and hold in the electronic ignition
button (5).Youwillhearitclicking.Checkthattheleftburnerislitbylookingthrough
thecookinggrates.Youshouldseeaflame(6).
m WARNING: Do not lean over the open barbecue.
D1) (MODEL3100ONLY)
Ignite center burner (7) by pushing control knob in and turning it to HIGH. Then,
push and hold in the electronic ignition button(5).Youwillhearitclicking.Checkthat
the center burner is lit by looking through the cooking grates.
OR
D2) (MODEL4100/4200)
a) Ignite center-left burner (8) by pushing control knob in and turning it to HIGH.
Then, push and hold in the electronic ignition button (5).Youwillhearitclicking.
Check that the center-left burner is lit by looking through the cooking grates.
b) Next, ignite center-right burner (9) by pushing control knob in and turning it to
HIGH. Then, push and hold in the electronic ignition button (5).Youwillhearit
clicking. Check that the center-right burner is lit by looking through the cooking
grates.
E) Ignite right burner (10) by pushing control knob in and turning it to HIGH. Push and
hold in the electronic ignition button (5).Youwillhearitclicking.Confirmthatthe
right burner is lit by looking through the cooking grates.
m WARNING: Each burner must be ignited individually by
pushing the electronic ignition button. Failure to do so may
cause a flare-up of gas which can cause serious bodily
injury and damage to property.
m WARNING: If any burner fails to ignite during lighting, within
five seconds, stop, turn the burner control knob to OFF and
wait five minutes to allow the gas to clear before you try
again or light with a match.
MAIN BURNER
ARRÊTÉ
- OFF -
APAGADO
5
2
LOW
HIGH
MED
1
2
3
4
5
6
7
10
3
4
5
8
9
1
6
2
10
3100
4100/4200