Desa (V)T32EP-A SERIES, (V)T32EN-A SERIES Outdoor Fireplace User Manual


 
www.desatech.com
116647-01B 23
Removing Glass Door
If replacement of glass is necessary, the entire
assembly, glass and frame, must be replaced. If
glass is broken, wear gloves and tape the remaining
fragments onto the frame.
1. Remove screen assembly by pushing the rod
either left or right and then down and forward
to remove screen/rod assembly from the re-
box. Set assembly aside.
2. Lift up on latches to unlock. There are two on
top of rebox and two below rebox that hold
glass door in place (see Figure 37).
3. While holding glass door to prevent it from
falling and causing injury, remove the ve
screws from the hinge located on the left side
of door frame assembly (see Figure 37).
4. Remount the new frame at the hinge with ve
new screws before closing door. This will
ensure seating of the gasket.
5. Close glass door frame. Lock latches by placing
the bar under the tab on door and pushing down
and back on latch (see Figure 37).
FIREPLACE
INSTALLATION
Continued
Figure 36 - Removing Louver Panel
Louver Panel
Spring Latch
Figure 37 - Removing/Replacing Glass
Door
Lock
Unlock
Glass Frame
Assembly
Screw
Hinge
Latch
6. Replace screen/rod assembly by reversing
step 1.
7. Replace louvers by reversing procedure under
Removing Louver Panels, page 22
Cleaning Glass Door
See Cleaning and Maintenance on page 28.
INSTALLING OPTIONAL BRICK
LINER MODEL bL32D
WARNING: If replace has
been running, turn off and un-
plug replace. Let cool before
installing brick liner.
This brick liner kit is optional. You may purchase
brick liner from your local retailer or see page 37.
CAUTION: Always handle
brick panels with two hands.
Do not force brick panels into
place. Excessive force will break
brick panels.
1. Remove top and bottom louvers to allow access
to door latches.
2. Unlock door latches and open glass door. See
steps 1 and 2 of Removing/Replacing Glass
Door, page 22.
3. If installing brick liner in new replace, go to
step 4. If installing brick liner in an existing
replace, carefully remove logs, lava rock and
ember material.
4. Remove three screws from deector shield on
the inside top of rebox. Set shield and screws
aside.
5. Install rear brick panel rst. Rest bottom edge of
panel on back edge of grate (see Figure 38).
Figure 38 - Installing Rear Brick Panel
Rear Brick
Panel