Desa VSGF33NRC Outdoor Fireplace User Manual


  Open as PDF
of 36
 
www.desatech.com
119304-01A18
7. Withcontrolknobpressedin,pressand
releaseignitorbutton.Thiswilllightpilot.
The pilot is attached to the front burner. If
needed,keeppressingignitorbuttonuntil
pilotlights.
Note:Ifpilotdoesnotstaylit,contacta
qualiedservicepersonorgassupplierfor
repairs.Untilrepairsaremade,lightpilot
withmatch.Tolightpilotwithmatch,see
Manual Lighting Procedure.
8. Keep control knob pressed in for 30 seconds
afterlightingpilot.After30seconds,release
control knob.
• If control knob does not pop out when
released,contactaqualiedserviceperson
orgassupplierforrepairs.
Note:Ifpilotgoesout,repeatsteps4
through8beginningonpage17.
9. Slightlypushinandturncontrolknobcoun-
terclockwise totheONposition.
10. Wait one minute and switch selector switch
totheONpositiontolightburners.
11. Setameadjustmentknobtoanylevel
betweenHIandLO.
WARNING: Make sure the
selector switch is in the OFF


Heater will come on automati-
cally with selector switch in the

Figure 29 - Pilot (Propane/LP)
Ignitor
Electrode
Pilot Burner
Figure 28 - Pilot (Natural)
Pilot Burner
Ignitor
Electrode
OPERATING FIREPLACE
Continued
TO TURN OFF GAS


1. Turn control knob clockwise to the
OFF position.
2a. Set selector switch in the OFF position.
2b. 
Set selector switch in the OFF position to
keepfromdrainingbattery.

You may shut off the burners and keep the pilot
litbydoingoneofthefollowing:
• Turn control knob clockwise to the
PILOT position.
• UseremotecontrolmanualOFFbutton.
• Set selector switch in the OFF position.
MANUAL LIGHTING

1. Followsteps1through6underLighting
Instructions,page17.
2. Depresscontrolknobandlightpilotwith
match.
3. Keep control knob pressed in for 30 seconds
afterlightingpilot.After30seconds,release
controlknob.Nowfollowsteps9through
11,column1.


Note: All remote control accessories must be
purchased separately(seeAccessories, page
32).Followinstructionsincluded withthe
remote control.

-
Lighting
Instructions
Afterlighting,letpilotameburnforabout
oneminute.TurncontrolknobtoONposi-
tion.Adjustameadjustmentknobanywhere
betweenHIandLO.Slidetheselectorswitch
totheREMOTEposition(seeFigure30,page
19).Note:Theburnermaylightifhand-held
remote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT: Donotleavetheselectorswitch
intheREMOTEorONpositionwhenthepilot
is not lit. This will drain the battery.
 previous next