Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
111923-01A
For more information, visit www.desatech.com
For more information, visit www.desatech.com
22
Lock
Unlock
Glass Frame
Assembly
Screw
Figure 42 - Removing/Replacing Glass Door
INSTALLING BRICK LINER MODELS
BL36DA(SA) AND BL36DHA(SA)
WARNING: If fireplace has been running, turn
off unit. Let cool before installing brick liner.
You may purchase brick liner from your local retailer or see
Accessories, page 36.
CAUTION: Always handle brick panels with two
hands. Do not force brick panels into place. Exces-
sive force will break brick panels.
1. Remove top and bottom louvers to allow access to door latches.
2. Unlock door latches and open glass door. See Removing/Re-
placing Glass Door, steps 1 and 2.
3. If installing brick liner in new fireplace, go to step 4. If install-
ing brick liner in an existing fireplace, carefully remove logs,
lava rock, and ember material.
4. Remove three screws from deflector shield on the inside top
of firebox. Set shield and screws aside.
5. Install rear brick panel first. Rest bottom edge of panel on back
edge of burner assembly (see Figure 43).
6. Install left side brick panel by sliding it between the burner
assembly and the side of the firebox (see Figure 43).
7. Install the right brick panel using the same method described
8. Replace deflector shield using screws removed in step 4.
9. Follow instructions to install logs, lava rock, and ember material.
10. Close glass door and lock latches on top and bottom of door
and replace screen. See Removing/Replacing Glass Door,
steps 5 and 6.
11. Close top and bottom louvers.
Hinge
Removing Glass Doors
If replacement of glass is necessary, the entire assembly, glass and
frame, must be replaced. If glass is broken, wear gloves and tape the
remaining fragments onto the frame.
1. Remove screen assembly by pushing the rod either left or right
and then down and forward to remove screen/rod assembly
from the firebox. Set assembly aside.
2. Lift up on latches to unlock. There are two on top of firebox and
two below firebox that hold glass door in place (see Figure 42).
3. While holding glass door to prevent it from falling and caus-
ing injury, remove the five screws from the hinge located on
the left side of door frame assembly (see Figure 42).
4. Remount the new frame at the hinge with five new screws
before closing door. This will ensure seating of the gasket.
5. Close glass door frame. Lock latches by placing the bar under the
tab on door and pushing down and back on latch (see Figure 42).
6. Replace screen/rod assembly by reversing step 1.
7. Replace louvers by reversing procedure under Removing
Louver Panels, page 21.
Cleaning Glass Door
See Cleaning and Maintenance on page 27.
Latch
FIREPLACE INSTALLATION
Continued
FIREPLACE INSTALLATION
Removing/Replacing Glass Door (Cont.)
Installing Optional Brick Liner Models BL36D(S) and BL36DH(S)
Figure 43 - Installing Rear Brick Panel
Rear Brick
Panel
Left Side
Brick Panel