Desa (V)K36EN SERIES Fire Pit User Manual


  Open as PDF
of 34
 
www.desatech.com
111924-01D 23
INSPECTING BURNERS
Check pilot ame pattern and burner ame patterns often.
PILOT ASSEMBLY
The pilot assembly is factory preset for the proper ame. Altera-
tions may have occurred during shipping and handling. The pilot
is located on the back right hand side of the burner.
The ame must envelope 1/4" of top of the ignitor/sensor and
grounding stem.
If your pilot assembly does not meet these requirements:
• Turn the adjustment screw marked PILOT clockwise to decrease
or counterclockwise to increase the ame to proper size (see
Figure 47, page 22). Do not remove the adjustment screw.
• see Troubleshooting, page 25
BURNER FLAME PATTERN
Burner ames will be steady; not lifting or oating. Flame patterns
will be different from unit to unit and will vary depending on instal-
lation type and weather conditions.
If the vent conguration is installed incorrectly, the ames will lift
or "ghost". This can be dangerous. Inspect the ames after instal-
lation to ensure proper installation and performance.
Figure 50 shows a typical ame pattern.
If burner ame pattern differs from that described:
• turn replace off (see To Turn Off Gas to Appliance, page 22)
• see Troubleshooting, page 25
Figure 50 - Typical Flame Pattern
Pilot Burner
Ignitor/Sensor
Figure 49 - Correct Pilot Flame Pattern
Sensing Rod
CLEANING AND
MAINTENANCE
    
cleaning.




may need more frequent cleaning due to excessive lint
from carpeting, bedding material, pet hair, etc.
GLASS DOOR
WARNING: Handle glass door panel with care. Do
-


WARNING: Do not use abrasive cleaners as this
may damage glass. Use a nonabrasive household glass
cleaner to clean glass. Do not clean glass when hot.
Glass must be cleaned periodically. During start-up it is normal for
condensation to form on the inside of the glass causing lint, dust,
and other airborne particles to cling to the glass surface. During
initial start-up a slight lm may form on the glass due to paint cur-
ing. The glass should be cleaned several times with a non-ammonia,
nonabrasive household cleaner and warm water after the rst two
weeks of operation. Thereafter, clean the glass two or three times
during each heating season, depending on the usage and circum-
stances present. Refer to Removing/Replacing Glass Door on page
18 of this manual when removing glass door for cleaning.
WARNING: Only parts supplied by the manufacturer
     
glass door panel (see Replacement Parts, page 27).
This glass door panel is a complete unit. No substitute
materials may be used.


glass is hot. Keep children and pets away from glass.
If glass has been broken, carefully remove glass door (see Remov-
ing/Replacing Glass Door, page 18). Vacuum all glass pieces with
a shop vac.

Use only the tempered glass door replacement intended for this
replace (see Replacement Parts, page 27 for detail on ordering).
No substitutions may be made. See Removing/Replacing Glass
Door, page 18 for instructions for replacing glass door.


 previous next