Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
13
105648
OWNER’S MANUAL
For more information, visit www.desatech.com
Notches
Figure 25 - Installing Fireplace Insert
Screen
Screws for
Mounting Screen
WARNING: You must operate
this fireplace insert with the fire-
place insert screen in place. Make
sure fireplace insert screen is in
place before running fireplace
insert.
INSTALLATION
Continued
OPTIONAL WIRELESS HAND-
HELD REMOTE CONTROL
ACCESSORIES
(GHRC and GHRCT)
Installing Remote Receiver Unit
1. Disconnect switch wires from the con-
trol valve.
2. Remove screws attaching switchplate.
3. Remove switch plate (see Figure 26).
Discard after removing.
4. Install remote receiver unit onto gas log
heater base using mounting clips.
5. Push clips firmly into place (see Fig-
ure 27).
6. Connect wires as shown in Figure 28.
Figure 26 - Switch Plate and Wiring
Harness
Figure 29 - Installing Battery in Remote
Receiver
Screw
Switch Plate
Wires
Figure 27 - Installing Remote Receiver
Installing 9-Volt Battery (Not
Included) in Hand-Held Remote
Control Unit
1. Remove battery cover on back of re-
mote control unit.
2. Attach terminal wires to the battery.
Place battery into the battery housing.
3. Replace battery cover onto remote con-
trol unit.
Figure 30 - Installing Battery in Hand-
Held Remote Control Unit (GHRC Series)
Battery
Cover
9-Volt
Battery
Terminal
Wires
Remote
Control Unit
Battery
Housing
Figure 28 - Connecting Wires
Red Wire From
Receiver
Valve
White Wire
From Receiver
INSTALLING 9-VOLT
BATTERIES
Two 9-volt batteries (not included) are re-
quired to operate this heater with the wire-
less hand-held remote control set. Install
one battery in the receiver and one in the
hand-held remote control unit.
Note:
Only
use alkaline batteries.
Installing 9-Volt Battery (Not
Included) in Receiver
1. Locate back of receiver under front
burner of heater.
Remote Switch
Bracket
Battery Clip
9-Volt Battery
Terminal Wires
Remote
Receiver
Ignitor
2. Locate the battery clip mounted on the
back of the receiver.
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
2. Install fireplace insert screen by slip-
ping notches of fireplace insert screen
over screws on front of fireplace insert
(see Figure 25).
Figure 31 - Installing Battery in Hand-Held
Remote Control Unit (GHRCTA Series)
Remote
Control
Unit
Remote Receiver
Mounting
Clips
Battery
Cover
9-Volt
Battery
Terminal
Wires