Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
www.desatech.com
116526-01B24
OPERATING FIREPLACE
Continued
5. Press in and turn control knob counter-
clockwise to the PILOT position.
Press in control knob for ve (5) seconds
(see Figure 38).
Note: You may be running this replace for
the rst time after hooking up to gas sup-
ply. If so, the control knob may need to be
pressed in for 30 seconds or more. This will
allow air to bleed from the gas system.
6. With control knob pressed in, press and
release ignitor button. This will light pilot.
The pilot is attached to the front burner. If
needed, keep pressing ignitor button until
pilot lights.
Note: If pilot does not stay lit, contact a
qualied service person or gas supplier for
repairs. Until repairs are made, light pilot
with match. To light pilot with match, see
Manual Lighting Procedure.
7. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob.
• If control knob does not pop out when
released, contact a qualied service person
or gas supplier for repairs.
Note: If pilot goes out, repeat steps 4
through 8.
8. Slightly push in and turn control knob coun-
terclockwise to the ON position.
9. Set ame adjustment knob to any level
between HI and LO.
CAUTION: Do not try to ad-
Figure 38 - Control Knob and Ignitor
Button Location (Shown as Supplied
- No Control Options)
Piezo
Ignitor
Button
Control
Knob
Flame
Adjustment
Knob
Figure 39 - Propane/LP Gas Pilot
Ignitor
Electrode
Pilot
Burner
Figure 40 - Natural Gas Pilot
Ignitor
Electrode
Pilot Burner
TO TURN OFF GAS
1. Turn control knob clockwise to the
OFF position.
2. If Using Optional Hand-Held Remote:
Set selector switch in the OFF position to
prevent draining battery.
You may shut off the burners and keep the pilot
lit by doing one of the following:
1. Turn control knob clockwise to the
PILOT position.
2. If Using Optional Hand-Held Remote: Use
remote control manual OFF button.
WARNING: Make sure re-
mote sensor selector switch is
in the OFF position when you
MANUAL LIGHTING
1. Follow steps 1 through 5 under Lighting
Instructions, starting on page 23.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 8 and 9
under Lighting Instructions.