Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
25
www.desatech.com
116035-01B
HEARTH ACCESS AND ASSEMBLY (Cont.)
Installing Logs and Glowing Embers
OPERATING FIREPLACE - Manual Ignition System
For Your Safety Read Before Lighting
HEARTH ACCESS AND ASSEMBLY
Continued
INSTALLING LOGS AND GLOWING EMBERS
A 4 piece ceramic log set comes packed inside the unit firebox.
Removal of glass door is necessary to unpack and assemble the logs
and add hearth treatments. Follow steps under Removing/Replacing
Glass Door, page 24 to access the logs and burner.
Assemble the logs and add burner treatments as follows:
1. Position the base log onto burner log mounts. (see Figure 56).
Note:
The cut out on the bottom should fit over the mounts
and the base log should be positioned against the rear panel
2. Position the holes on the bottom of the rear log over the pins
on the base log Figure 53).
3. Position the top left log and top right log onto the rear log
and base log as shown in (see Figure 54).
BURNER
PAN
REAR
PANEL
REAR LOG
STAND
LOG
MOUNTS
REAR
LOG
TOP
RIGHT
LOG
TOP
LEFT
LOG
Figure 56 -
Installing Logs
4. Open the bag of ember materials.
5. Break apart about quarter sized pieces and place about a
single layer along the full length of the ember tray to hide
the bottom edge of the base log. (see Figure 57).
6. Replace the glass door and louver panels. See Removing/
Replacing Glass Door, page 24.
WARNING:
The glass door must be securely in
place before running this fireplace. Do not run this
fireplace if glass is missing or broken.
Figure 57 -
Applying Ember Material
OPERATING FIREPLACE
Manual Ignition System
FOR YOUR SAFETY READ
BEFORE LIGHTING
WARNING:
If you do not follow these instructions
exactly, a fire or explosion may result causing prop-
erty, damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floorbecause some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone
in your building.
• Immediately call your gas supplier from a neighbor’s
Phone. Follow the gas supplier’s instructions.
EMBER
MATERIAL
EMBER
TRAY