Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Page 19
1
2
3
4
5
6
7
8
9
10
11
Reference numbers
#
1 -
#
3 -
#
6 Are U-Joints -- Check and grease regularly.
Reference number
#
2 - Is a Telescoping P.T.O. Shaft with two slots in housing -- Fully extend P.T.O. Shaft,
then place one or two pumps of grease in each slot.
Reference numbers
#
4 -
#
5 Are fixed self centering sealed bearings -- Do not over grease sealed bearings.
Reference number
#
7 - Auger gear box is filled with 80-90 gear lube -- To check gear box find inspection allen
plug. Turn out plug. Gear lube should just start to run out. If low fill until gear lube just starts to run out.
Should be about 24-26 oz. of 80-90 gear lube. DO NOT OVER FILL!!! When gear box is full be sure to replace
inspection plug.
Reference number
#
8 - Is a bushing for the turn handle of the door lift assembly -- Inspect and grease as
needed.
Reference numbers
#
9 -
#
11 - Are fixed sealed bearings -- Do not over grease sealed bearings.
Reference number
#
10 - Is the hinge for the outer tube. There are two zerks in this area -- Inspect and
grease as needed.
Reference number
#
12 - Is the axle hub with inner and outer bearings and races -- Inspect regularly, pack
bearing and replace inner wheel seal as needed.
Reference number #13 - Is four bushings on the inner door. There are four grease zerks on this door--Inspect
and grease every 20 hours. Also Lube the guide rods with a good lubricant at this time.
NOTE. Grease all zerks before each use or when needed with a good quality lubricant.
Do Not over grease sealed bearings. Over greasing sealed bearing will
damage seals. Once a season is generally sufficient.
GREASE & LUBE
12
13 - Inside The Box