Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
L 15,000 TO 30,000 BTU/HR
..T.
ASSEMBLY
ASSEMBLING HEATER
Tools Required:
• Phillips Screwdriver
• 5/16" hex wrench
• Slotted screwdriver
Removing Front Panel Of Heater
1. Remove two screws near bottom cor-
ners of front panel with Phillips screw-
driver.
2. Pull bottom of front panel forward, then
down (see Figure 2).
Installing Log
Note: For easier installation, lay heater on
its back.
1. Remove log from inside top of heater.
Discard protective packaging.
2. Attach ignitor cable to piezo ignitor
(see Figure 3).
3. With Phillips screwdriver, remove four
screws holding screen in place. Re-
move screen,
4. Gently slide log between log retaining
brackets on deflector assembly (see Fig-
ure 4). The log should fit firmly against
bottom of log retaining brackets,
5. Reattach screen using four screws re-
moved in step 3.
_b, WARNING: Always have
burner shield and screen In place
before operating heater.This pre-
vents excessive temperatures on
heater surfaces.
Failure to position the parts in
accordance with these diagrams
or failure to use only parts spe-
cifically approved with this heater
may result in property damage or
personal Injury.
Piezo Ignitor
,Ignitor
Cable
\.
Figure 2-RemovingFrontPenelofHeater
Log
Figure 3 - Allachlng Ignitor Cable to Plezo
Ignitor
Heater Cabinet
Deflector
I
Screen J
FrontPanel
\
Truss
Head
Screw
Brass
Front Tdrn
Screw
Figure 4 - Assembling Heater
Attaching Brass Front Trim to
Front Panel
1. Locate brass front trim in brass trim
package.
2. Slide the head of two truss-heed screws
from hardware packet into each end of
brass front trim (see Figure 5).
3. Line up screws with boles in front panel
(see Figure 4). Insert screws in holes.
Attach nuts from inside of front panel.
Tighten with wrench.
Log
Retaining
Brackets
_J
BumerShield
Screw
BrassFront
Trim
Nut
Truss-Head
Screw
Figure 5 - Attaching Brass Front Trim to
Front Panel
4 104434