Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
ÖÖ
Attach an LP Cylinder to the
Grill.
35-A
Cylinder Support
LP Cylinder
35-A. Set LP Cylinder in the Cylinder Support with the outlet
valve facing toward the front of the grill.
35-B
35-B. Tighten the Cylinder Retainer Bolt against the bottom
cylinder collar.
Cylinder Retainer Bolt
35-C
35-C. Insert the TYPE 1 Nipple of the regulator into the cylin-
der’s Fuel Valve Outlet as shown. Turn the regulator
hand wheel clockwise to tighten. No tools are needed.
The hand wheel will come to a complete stop when the
connection is secure, and gas will not flow until a positive
seal is achieved. For leak-check procedure, read and fol-
low the steps identified on page 36.
IMPORTANT!
TO ENSURE PROPER GAS FLOW, BURNER
CONTROL VALVES MUST
BE “OFF” BEFORE
OPENING THE GAS CYLINDER VALVE.
WARNING: During assembly of
grill and when attaching or replacing the
L.P. gas cylinder, insure that the gas sup-
ply hose is free of kinks and/or damage
and is at least 3” away from hot surfaces
such as the grill casting.
Step
35
NOTE: Step 35 applies to you only if your grill is set up from the factory to use LP GAS. If your grill is set up from the factory to
use NATURAL GAS, skip to Step 36.
Type 1 Nipple
Fuel Valve Outlet
34