Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
OPERATING THE QUICK-CONNECT
Follow all directions on tags attached to hose.
1. To connect the fuel-supply hose to the fuel
supply, the shut-off valve must be closed.
2. Remove the dust cap from the connector
socket by sliding the connector sleeve back to
release the plug. Remove the dust cap from the
plug.
3. Position the plug end of the fuel supply hose
into the sleeve opening.
4. Slide the connector sleeve back, firmly push
the fitting into the connector.
Model 7000N • Connecting to Natural Gas
(for specially equipped natural-gas grills only)
22
5. Push the plug into the connector until the
sleeve snaps forward to lock the fitting in
place. Turn on the shut-off valve. The flow of
gas to the appliance will be restricted if the
plug is not connected properly.
6. Test for gas leaks using an ammonia-free
soap and water solution.
TO DISCONNECT THE FUEL SUPPLY
1. Pull connector sleeve back and pull plug
out of socket. This will automatically shut off
gas to the appliance.
2. Close the shut-off valve and install the dust
caps on the socket and plug. Always turn off
the fuel supply at the shut-off valve when the
grill is not in use.
LEAK TEST CONNECTIONS
Test all the fuel supply connections using a
an ammonia-free soap and water solution
equally mixed. Never use fire to test for leaks.
Turn on the gas shut-off valve
1. Coat all connections of the fuel supply sys-
tem, especially at the quick-connect.
2. Watch for bubbles to indicate a leak.
3. If there is a leak, shut off the gas supply
and re-connect the hose to the socket.
Re-test for leaks.
Do not use the grill if a leak is detected that
cannot be corrected in this manner or if the
hose and connections become damaged.
Replace damaged components with only fac-
tory authorized parts.
Do not strain or kink the fuel-supply hose.
See that the hose is kept clear of surfaces that
become hot during use.
Plug
Connector Sleeve
Dust Cap
Shut-off Valve