Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Section C Con’t.
12
C5
Reinstall Tube Burners
Insert Tube Burners into Firebox Burner holes over Valves with Ignitor Assembly downward, making sure Tube Burner engages Valve
properly. See illustration below.
Secure Tube Burners to Burner Brackets with previously removed Hitch Pins. Replace Carryover tubes and secure with Hitch Pins
previously removed. Reference illustration C1.
Reinstall Searing Burner with previously removed Screws, Lock Washers and Flat Washers. Reference illustration C3.
Make sure Searing Burner engages Valve properly. See illustration below.
Pull the Tube Burner Control Knob off of Valve Stem.
Remove two Screws and two Washers that secure Bezel to the Control Panel. Save removed Bezel for converting back to LP Tank
Gas.
Install new Natural Gas Bezel provided with Kit (see illustration below) in place of old Bezel onto Control Panel, and secure using
previously removed Screws and Washers. Assure proper alignment with control knob before fully tightening. Note: New bezels will
change the rotation for the control knob to properly control ignition and flames for your grill.
Press Control Knob back onto Valve Stem. Make adjustments needed to Bezel for free movement of Control Knob
Repeat for each Bezel.
C6
Bezels must be replaced one at a
time. Removing more than one bezel
at a time may cause misalignment of
manifold.
Incorrect
burner-to-valve
engagement
Correct
burner-to-valve
engagement
Tube Burner
Tube Burner
Control Knobs
Bezels
Valve
Stem
Lock Washers
Screws
Control Panel
Large Bezel
Hi
Low
OFF
Med
WARNING
Correct
burner-to-valve
engagement
Incorrect
burner-to-valve
engagement
Searing Burner