Char-Broil 4539937 Gas Grill User Manual


  Open as PDF
of 24
 
Main Burner Conversion (Cont.)
7
- Using a #2 Phillips screwdriver, reinstall the two #8x3/8” screws that attach the Orifice Holder to the burner flange. Repeat for each Orifice
Holder. DO NOT over-tighten the Orifice Holder screws.
Re-install 2 #8x3/8”
screws into
Burner Flange.
Orifice
Holder
Burner
Flange
- Pull the Burner Control Knobs off of Valve Stems.
- Remove screws and washers that secure each Bezel to the Control Panel. Remove Bezels. Save removed Bezels for converting back to LP
Tank Gas.
- Install new Natural Gas Bezels provided with Kit (see illustration below) in place of old Bezels onto Control Panel, and secure using previously
removed screws and washers. Assure proper alignment with control knob before fully tightening.
- Press Control Knobs back onto Valve Stems. Make adjustments needed to Bezels for free movement of Control Knobs.
Replace Main Burner Bezels and Control Knobs
NOTE: REPLACE ONE BEZEL AT A TIME. DO NOT REMOVE ALL THE BEZELS AT THE SAME TIME.
Note: New bezels will change the rotation
for the control knob to properly control ignition and flames for your grill.
8
Natural Gas Bezel
80004350
NOTE: Replace only one
bezel at a time!
16
Valve
Stem
Bezel
Main Burner
Control Knob
Screw
Screw
 previous next