Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
-
- While holding the adjustable wrench firmly, use the Orifice Driving Tool to loosen and remove the Orifice by turning it counter-clockwise.
- Save the removed orifice for converting back to LP gas.
Remove LP Orifices
Pull the Orifice Holder and the gas tubing away from the Burner Flange. The gas tubing is flexible and will allow sufficient clearance to
complete this conversion.
Using an adjustable wrench, not provided, place the wrench securely on the Orifice Holder in the area shown below.
DO NOT twist or crimp the Gas Tubing. To do so may result in Gas Leakage.
-
5
Main Burner Conversion (Cont.)
Orifice
Orifice Driving
Tool
Orifice
Holder
Place Adjustable Wrench
Here While Removing
Orifice
I
NOTE: Tighten the
orifice sufficiently to prevent gas leakage. DO NO over-tighten. DO NOT use any tool other than the Orifice Driving Tool!
nstall Natural Gas (NG) Orifices
-
- While holding the adjustable wrench firmly, use the Orifice Driving Tool to tighten each Orifice by turning it clockwise.
Using your fingers, thread the Main Burner NG Orifice(#55 Yellow Dot Orifice) into each orifice holder 2-3 turns, clockwise.
Using an adjustable wrench, not provided, place the wrench securely on the Orifice Holder in the area shown below.-
6
#55 Yellow Dot Orifice
Orifice Driving
Tool
Orifice
Holder
Place Adjustable Wrench
Here While Removing
Orifice
15