Char-Broil 06601295 Gas Grill User Manual


 
Safety Tips
sBefore opening LP tank valve, check the coupling nut for
tightness.
sWhen grill is not in use, turn off control knob and LP tank
valve.
sNever move grill while in operation or still hot.
sUse long-handled barbecue utensils and oven mitts to avoid
burns and splatters.
sThe grease cup must be attached to grease clip and emptied
after each use. Do not remove grease cup until grill has
completely cooled.
sIf you notice grease or other hot material dripping from grill
onto valve, hose or regulator, turn off gas supply at once.
Determine the cause, correct it, then clean and inspect valve,
hose and regulator before continuing. Perform a leak test.
sThe regulator may make a humming or whistling noise during
operation. This will not affect safety or use of grill.
sIf you have a grill problem see the "Troubleshooting Section".
NEVER attempt to light burner with lid closed. A buildup
of non-ignited gas inside of closed grill is hazardous.
Never operate grill with LP tank out of correct position
specified in assembly instructions.
Always close LP tank valve and remove coupling nut
before moving LP tank from specified operating
position.
WARNING
CAUTION
Putting out grease fires by closing the lid is not
possible. Grills are well ventilated for safety reasons.
Do not use water on a grease fire. Personal injury may
result. If a grease fire develops, turn knobs and LP
tank off.
Do not leave grill unattended while preheating or
burning off food residue on HI. If grill has not been
regularly cleaned, a grease fire can occur that may
damage the product.
WARNING
Never attempt to attach this grill to the self-contained
LP gas system of a camper trailer or motor home.
Do not use grill until leak-tested.
Hose Check
Before each use, check to see if hoses are cut, worn or
kinked. Replace damaged hoses before using grill. Use only
valve/hose/regulator specified by manufacturer.
Normal
Hose
Kinked
Hose
Turning Grill Off
Turn knob to OFF position. Turn LP tank hand wheel
clockwise to a full stop.
Ignitor Check
Turn gas off at LP tank. Press ignitor button rapidly. “Click”
should be heard each time at electrode. See Troubleshooting
section if not click is heard.
Valve Check
Important: Make sure gas is OFF at LP tank before
checking valve. Knob locks in place. To check valve, first
push in knob and release, knob should spring back. If knob
does not spring back, replace valve assembly before using
grill. Turn knob to LOW position then turn back to OFF
position. Valve should turn smoothly.
Before Your First Cookout
Light burner, check to make sure it is lit, close the lid and warm
up grill on HIGH for 15 minutes. Curing of paint and parts will
produce an odor only on first lighting.
Burner Flame Check
1. Light burner in grill bottom using long-stem match as
described in Match Lighting.
2. Push in and rotate knob from HIGH to LOW. You should see
a noticeably smaller flame in LOW position from that seen in
HIGH position. Always check flame, as described above, prior
to each use
s Let grill cool before placing briquets.
Ignitor Lighting
sDo not lean over grill while lighting.
1. Open lid. Turn on gas at LP tank.
2. Push in and turn knob on control leg to HIGH.
3. Push IGNITOR button rapidly to light. Be sure burner lights
and stays lit.
4. If IGNITOR does not work, follow match lighting instructions.
CAUTION
If burner does not light, turn knob(s) to , wait 5
minutes, try again. If the burner does not ignite with the
valve open, gas will continue to flow out of the burner
and could accidentally ignite with risk of injury.
OFF
6 • 06601295