Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
8
Lighting the SEAR ZONE Infrared Burner (if applicable)
1. Open Sear Zone Side burner lid. Ensure all control knobs in the OFF position
before opening the gas supply.
2. Turn on the gas supply valve at the tank (1 to 2 turns) or turn on the main gas
supply valve.
3. Turn the Sear Zone burner control knob to the SEAR/ “HI” position.
4. Press and hold ELECTRONIC IGNITER button.
5. If the Sear Zone does NOT light, turn knob to OFF, turn o LP or NG gas, wait
5 minutes, and then repeat lighting procedure.
6. If the Sear Zone burner still does not light follow the match lighting procedure for the Sear Zone.
WARNING
With models with Sear Zone infrared burner included in main cooking area, never operate main BBQ
burners in conjunction with Sear Zone infrared burner unless BBQ lid is left open. Using the Sear Zone
main burners with the BBQ lid closed may result in overheating your BBQ, re, explosion, personal
injury or property damage.
Match lighting the Sear Zone Infrared burner (if applicable)
1. Open lid Sear Zone side burner lid. Ensure all Control knobs are in the OFF position before opening the gas supply.
2. Turn on the gas supply valve at the tank (1 to 2 turns) or turn on the main gas supply valve.
3. Place a lit match or a butane lighter directly beside the Sear Zone electrode.
4. Turn the Sear Zone control knob to the SEAR/ “HI” position. Be sure the burner lights and stays lit.
ATTENTION
Always preheat barbecue before starting to cook. Light all burners and adjust them to the HIGH position
for 5 to 10 minutes with the lid closed. Following preheat; adjust the controls to medium setting for most
cooking requirements.
Turning Grill O
1. Turn all knobs to OFF position.
2. Turn LP cylinder o by turning hand-wheel clockwise to a full stop or turn o natural gas supply valve.
WARNING
If the heat output is too low, the ow control feature may have been activated by a gas leak or improper
lighting procedure. If so, turn o the burner valve and cylinder valve, and perform a “Leak Test”. If there
are no leaks, perform a complete regulator ow limiting device reset.
Valve Check
Important: Make sure gas is o at LP cylinder before checking valves. Knobs lock in OFF position. To check valves, rst
push in knobs and release, knobs should spring back. If knobs do not spring back, replace valve assembly before using grill. Turn
knobs to LOW position then turn back to OFF position. Valves should turn smoothly.
VERY IMPORTANT: Burner tubes must engage valve space openings.
See illustration at right.
1. Attach electrode to burner.
2. Carefully replace burners.
3. Attach burners to brackets on rebox.
4. Reposition carryover tubes and attach to burners.
Replace ame tamers and cooking grates.
Centro 6800 only.
Ensure burner sits
properly over valve.