Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7
Match-Lighting Main Burners
1. Open lid. Turn o all control knobs. Ensure LP cylinder is closed.
2. Turn on the gas supply valve at the tank (1 to 2 turns) or turn on the main gas
supply valve.
3. Insert a lit match or a butane lighter into the match lighting hole located on
the left hand side or right hand side of the barbecue cart (on the under side
of the burner side shelf).
4. Turn the selected burner control knob, either the far right or far left, to the
HIGH position. Be sure the burner lights and stays lit.
5. Light adjacent burners in sequence by pushing knobs in and turning to “HI”.
Lighting the SIDE BURNER (if applicable)
1. Open side burner lid. Conrm that all burner control knobs are in the OFF position before opening the gas supply.
2. Turn on the gas supply valve at the tank (1 to 2 turns) or turn on the main gas supply valve.
3. Turn the burner control knob to the “HI” position.
4. Immediately activate the Igniter. The selected burner should light within ve seconds.
5. If ignition does NOT occur in 5 seconds, turn the burner control OFF, wait 5 minutes for the gas to clear and repeat the
lighting procedure.
6. If the burner will not light when using the ignitor, follow the match
lighting instructions.
WARNING
Do not lean over grill while lighting.
Match lighting the SIDE BURNER (if applicable)
1. Open lid. Turn OFF all control knobs. Ensure LP cylinder is closed.
2. Turn on the gas supply valve at the tank (1 to 2 turns) or turn on the main gas
supply valve.
3. Insert a lit match or a butane lighter under the side burner grate.
4. Turn the side burner control knob to the “HI” position. Be sure the burner lights
and stays lit.
CAUTION
If ignition does NOT occur in 5 seconds, turn the burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with the valve open, gas will continue to ow out of
the burner and could accidentally ignite with risk of injury. Turn controls and gas source OFF when
not in use.
WARNING:
Never operate main BBQ burners in conjunction with the Rotisserie burner, as this may result in
overheating your BBQ, re, explosion, personal injury or property damage.
Lighting the ROTISSERIE BURNER (if applicable)
1. Open BBQ lid. Ensure all control knobs in the OFF position before opening the gas supply.
2. Turn on the gas supply valve at the tank (1 to 2 turns) or turn on the main gas supply valve.
3. Turn the Rotisserie burner knob to the “HI” position.
4. Press and hold ELECTRONIC IGNITER button.
5. If the Rotisserie burner does NOT light, turn knob to OFF, wait 5 minutes, and then
repeat lighting procedure.
6. If the Rotisserie burner still does not light follow the match lighting procedure for the Rotisserie burner.
Model may not be exactly as shown.
Model may not be exactly as shown.
Model may not be exactly as shown.