Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
GAS SUPPLY HOSE VENTURI TUBES
1. On models supplied with an extension hose, the hose
assembly is specifically designed for your model. No
modifications or additions should be attempted. Hose
and hose couplings comply with CGA Standard CAN
1.83.
2. On models equipped with the "quick disconnect"
coupling, close "shut off valve" before disconnecting
coupling.
3. "Quick disconnect" coupling must be kept clean and
free of dirt and debris.
4. Protect the hose from dripping grease and do not allow
the hose to touch any hot surface, including the base
casting of the barbecue.
5. Inspect the hose at least once per year. If the hose is
cracked, cut, abraded or damaged, the appliance must
not be used.
6. For replacement of hose assembly, contact your dealer
or approved service centre.
4
A. GAS SUPPLY PIPING
B. QUICK DISCONNECT COUPLING
C. ADAPTER FITTING
D. EXTENSION HOSE ASSEMBLY
E. LEAK TEST HERE
• KEEP VENTURI TUBES CLEAN.
• Blockages caused by spiders insects and nests
can cause a flashback fire.
Although the barbecue might still light, the backed up gas
might also ignite and cause a fire around the venturi tubes
at the control panel or side burner.
VENTURI TUBE SPIDER WEB
• If a flashback fire occurs, turn off gas at the
source immediately
Inspect and clean the venturi tubes (main burner, side
burner, rear burner) if any of the following symptoms
occur:
1. You smell gas.
2. Your barbecue does not reach temperature.
3. Your barbecue heats unevenly.
4. The burners make popping noises.
Inspecting & Cleaning Venturi Tubes
1. Turn off gas at the source. i.e. the gas cylinder or
supply line for natural gas.
2. When barbecue is cool, remove burner fasteners from
bottom, lift the burner from the barbecue housing.
3. Clean the venturi tubes with a pipe cleaner or venturi
cleaning tool (Accessory #18270).
4. Lower the burner into position in the barbecue
housing, making sure that the venturi tubes are
correctly aligned and fitted on the orifices.
5. Secure burner with burner fasteners.