Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
B101525-4-0411Page 26
Installing Racks
Place the briquet rack or on the burner assembly.
Position the are busters on the briquette rack or the ceramic
briquets evenly on the briquette rack without overlapping.
See Figures 16a and 16b.
For Smoker Shutter installation see DPA100 manual included
with your P3SX grill.
Set the multilevel cooking grids. See Figures 17a and
17b.
Figure 17a
Installing Char-Master Briquets
Individually place the ‘Char-Master’ briquets in a single layer
evenly on your grill’s briquet rack; DO NOT dump them onto
the briquet rack. A single layer of ‘Char-Master’ briquets is all
that’s needed. DO NOT overlap or stack the briquets.
See Figure 17b.
After properly placing the ‘Char-Master’ briquets on your
grill’s briquet rack, there may be some briquets left over.
Save them for future use.
Before cooking, always preheat the grill as directed by the
grill’s operating instructions. Hot briquets cause better,
quicker cooking and better avor.
Cleaning
Routine preheating and routine burn-off (also called post-
heating) of a grill will clean the ‘Char-Master’ briquets. Peri-
odically turn the briquets over while they are cool.
Note for H3 Package Owners: The side shelf must be in-
stalled before installing the Briquets and Briquet Rack. See
side shelf installation on page 51.
Figure 17b
GRILL ASSEMBLY