Broilmaster P3BL-2 Gas Grill User Manual


 
Page 17B101362-2-0610
1/8"
ORIFICE
HOOD
NUT
SUPPLY
TUBE
48
WRENCH
SUPPLY
TUBE
ORIFICE HOOD
HOSE AND REGULA TOR
SUPP LY TUBE
HOSE AND REGULATOR
SUPPLY TUBE
ORIFICE HOOD
Propane grills include a conversion kit for natural gas. If you have
a natural grill and wish to convert it to propane you will need to
purchase the optional conversion kit BCK1003.
Begin by removing all the components from the inside of your grill.
Locate and remove the orice hoods mounted on the underside of
the grill body, using 2 wrenches as shown. See Figure 13.
Gas Conversion
Before installing the natural hoods, inspect them for damage and
note the number stamped on the side. The correct hood will be
marked 48".
The hoods are self-sealing, requiring no additional pipe sealant. If
you wish to use sealant, take care to add it to the threads only to
avoid blocking the orice.
Thread the hoods onto the supply tubes leaving about a 1/8" gap
between the hood and the locking nut. See Figure 14.
Remove the hose and regulator from the valve.
Replace the components inside of your grill.
Remove the knobs from the valve assembly and locate the adjust-
ment screws on the inside of the valve stem. Using a small screw
driver, turn the screws clockwise until screw bottoms, then turn
the screws four (4) FULL turns counterclockwise. Do not back the
screws out more than 4 1/2 turns or a leak may result.
See Figure 15.
Connect the grill to the natural gas supply.
Important: Before lighting your grill, check the gas connec-
tions and the adjustment screws for leaks using a soapy water
solution.
Caution: Never use this or any gas appliance which may be
leaking gas.
Replace the knobs.
ADJUSTMENT SCREW
VALVE STEM
CONTROL PANEL
OFF
3
HI
OFF
RIGHT
3
HI
LEFT
1
LO
2
LO
2
1
Figure 13
Figure 14
Figure 15
Place the completed conversion label adjacent to the product iden-
tication label, located on the control panel (26).
NOTE: When converting your grill to Natural gas and your incom-
ing gas pressure is below 7" (water column), a DPA105 regulator
kit can be purchased.
GAS CONVERSION