Broilmaster P3BL-2 Gas Grill User Manual


 
Page 10 B101362-2-0610
Ignitor Assembly
Slide the collector box spacer (26) and nut (provided on assembly)
onto the collector box shaft and tighten. See Figure 1.
Note: Peel protective lm from control panel label before
installing ignitor.
Installing the Ignitor
Caution: Do not cut or damage ignitor wire.
Carefully thread the end of the ignitor wire through the center hole
in the grill bottom. Slide the ground lug (25) over the ignitor wire
and fasten with nut provided.
Attach one end of the ground wire (24) to the terminal on the rear
of the electronic ignitor. Attach the remaining end to the ground
lug. See Figures 1 and 2.
Attach ignitor wire to the spark terminal on the rear of the elec-
tronic ignitor.
Nut
25
24
21
19
Figure 1
24
Figure 2
25
27
26
25
24
GRILL ASSEMBLY