Broilmaster D3-1 Gas Grill User Manual


 
Page 18 B100691-0-0103
Checking for Gas Leaks
Check for gas leaks every time you connect
your Broilmaster
®
propane gas grill to a Propane
gas cylinder, when a connected cylinder has not
been used recently, or when either a natural or
propane grill is being used for the first time.
CAUTION: DO NOT USE AN OPEN FLAME WHEN CHECKING
FOR
LEAKS. CHECKING FOR LEAKS WITH AN OPEN FLAME
MAY
LEAD TO A FIRE OR EXPLOSION, RESULTING IN
PROPERTY
DAMAGE OR PERSONAL INJURY.
To check for gas leaks:
1. Use dish washing liquid and a little water to
make a soapy solution.
2. Turn OFF the knob on the control panel.
3. Turn ON the gas at the supply or cylinder. A
hissing sound indicates a leak. Turn OFF the
gas and repair the leak.
4. Apply the soapy water solution to all gas
connections.
5. Look for bubbles. Bubbles indicate a leak.
6. If there are bubbles turn OFF the gas and repair
the leak.
7. Turn the gas back ON and repeat the above
procedures until all leaks are repaired.
Operating Instructions
Using the Igniter
CAUTION: IF A BURNER FAILS TO LIGHT AFTER 5
SECONDS, TURN THE BURNER OFF FOR 5 MINUTES,
TO ALLOW THE GAS TO CLEAR, THEN TRY AGAIN.
1. Turn knob on the grill CLOCKWISE to the
OFF position.
2. Turn ON gas at the source.
3. With the grill lid open, push and turn the burner
control knob COUNTERCLOCKWISE to Hi.
4. Push and hold the igniter button until the
burner lights (approximately 5 seconds).
5. If a burner does not light, turn OFF all gas
and refer to the Troubleshooting section of
this manual.
Air Shutter Adjustment
The venturi air shutter(s) are preset at the
factory so that after five minutes the burner
flames are blue with well defined cones. If, after
five minutes the flame is yellow, or there is a gap
between the burner and the flame, adjust the
venturi air shutter as follows:
1. Turn gas OFF and let the burner cool.
2. Loosen shutter set screw
3. Close the air shutter to the minimum opening.
Refer to Figure 5.
4. Light the burner, wait five minutes and then
carefully open the air shutter until the flame is
blue and well defined.
5. Retighten the set screw.
OPERATION - PROPANE & NATURAL GRILLS
Operating Instructions
Using Matches
CAUTION: IF A BURNER FAILS TO LIGHT AFTER 5
SECONDS, TURN THE BURNER OFF FOR 5 MINUTES,
TO ALLOW THE GAS TO CLEAR, THEN TRY AGAIN.
1. Turn knob on the grill CLOCKWISE to the
OFF position.
2. Turn ON gas at the source.
3. Open the grill lid.
4. Insert a burning long wooden match through
the lighter hole on either side of the grill.
5. Turn the burner control knob
COUNTERCLOCKWISE to HI.
6. If a burner does not light, turn OFF all gas
and refer to the Troubleshooting section of
this manual. F
IGURE 15.
FIGURE 15