Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
5
Step 6
Install the leg brace (without the L-bracket)
to the mounted legs using four self tapping
screws. Securely tighten the screws and leg
hex nuts. Do not overtighten.
Step 7
Attach the other two legs (with wheel axles)
to the smoker. First, insert the wire rack into
the leg, then move bolted end of leg until
bolts align with holes in the cooking
chamber. Insert bolts and place a flat washer
and hex nut over each bolt and hand tighten
only. Repeat this step on last leg.
NOTE: Leg brace with L-bracket is not
attached until Step 12, after the firebox
has been attached and the smoker is in
an upright position.
Step 8
Attach the door latch to the outside of the
firebox door as illustrated. Do not
overtighten hex nut.
Step 9
To install air vent damper, open the firebox
door and attach damper to inside of firebox
door as illustrated. Do not overtighten as this
will make the air vent difficult to open and
close.
Step 10
Close firebox lid and door. Carefully place the
firebox on top of the large chamber. Open
firebox lid and align the holes of both
chambers and secure with 4" x w" bolts.
Use two flat washers per bolt as illustrated
(one in the firebox and one in the cooking
chamber).
Step 11
Keeping lids closed and with the help of an
assistant, carefully turn the smoker to its
upright position. Try to minimize the stress
placed on the legs.
CAUTION: Keep lids closed when setting unit
upright to prevent bodily injury.
Step 12
Attach leg brace with L-bracket to the legs
with wheel axles using self tapping screws.
When attaching leg brace, it may be
necessary to slightly loosen leg nuts to align
the holes.
Cooking
Chamber
Begin
Bolting
Here
Firebox
4" Hex Nut
4" Flat Washer
Door Latch
Air Vent
Butterfly Damper
4" Lock Washer
Leg Brace without
L-Bracket
Smoker
Chamber
Wire Rack
Legs with Axles
Top View Bottom View
Inside of
Firebox Door
Flat
Washer
4" Hex Nut
4" Flat Washer