Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
STEP 1:
a. Turn base pan upside down to assemble. Attach leg brackets to base
pan with 10-24 x s" screws and square nuts.
NOTE: The two screw holes in tube portion of leg bracket must align to
point to center of base pan.
b. Insert end of leg with two holes into leg bracket and align holes. Make
sure the single hole on opposite end of leg is facing center of base
pan. Fasten with a 10-24 x 12" screw and square nut.
NOTE: Prior to placing another leg into leg bracket, insert hook of
chrome triangle into single hole of attached leg. Make sure the
entire hook is inserted into leg.
c. Insert hook of the chrome triangle into second leg by turning leg into
place as illustrated above. Insert leg into leg bracket. Align holes and
fasten with a 10-24 x 12" screw and square nut. Repeat procedure for
remaining leg.
d. Install plastic leg caps on the end of legs.
STEP 2:
a. Set base pan assembly upright.
b. Connect regulator hose to gas valve assembly using
7
/16" wrench.
Tighten securely.
NOTE: Use pipe thread compound suited for gas to properly seal
connection.
c. Insert gas valve stem through center hole in the control panel. Attach
gas valve assembly to back of control panel using two 6-32 hex head
nuts.
d. Install burner control knob by pressing knob onto the gas valve stem.
e. Insert rotary gas ignitor stem through the designated hole in the con-
trol panel. Attach rotary gas ignitor to back of control panel using two
8-32 x 4" thread cutting screws. Do not over-tighten.
f. Install ignitor knob by pressing knob onto the rotary gas ignitor stem.
10-24 x s"
screws
Base Pan
Legs
10-24 x 12"
screw
Leg Brackets
Square Nuts
Base Pan
View from Bottom
Single
Hole
Chrome Triangle
Plastic
Leg Caps
Gas Valve
Assembly
Rotary Gas
Ignitor Stem
Gas Valve
Stem
Burner Control
Knob
6-32
Hex Nuts
Ignitor
Knob
8-32 x 4"
Thread
Cutting Screws
Rotary Gas
Ignitor
Control Panel
4