Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
COOKING GRILLS
• Clean with mild soap detergent and water. A brass bristled brush or a nylon cleaning pad can be used
to remove residue from the cast iron cooking surface. Do not use steel wire bristles to clean the cast
iron cooking grills. Steel can cause the finish to chip or crack. DO NOT use a commercial oven
cleaner.
CERAMIC BRIQUETS
• Periodically, it may be necessary to inspect and clean the ceramic briquets to prevent excess grease
build-up. When the grill is cold, remove the cooking grills. Inspect each briquet and replace briquets that
are broken, chipped or damaged to the extent that it may fall through the briquet grate and onto the
burner. Replace the cooking grills and light the main burner. Operate the grill on "HIGH" for 10 minutes
to remove the excess grease. If purchasing replacement ceramic briquets, purchase only large briquets
that will not fall through the briquet grate as grease build-up on the briquets could result in grease fire.
• Always make sure that the ceramic briquets are laying flat side down on the briquet grate.
TROUBLE SHOOTING:
Problem: Possible Causes:
• Burner will not light
1. Check LP cylinder fuel level.
2. Bad electrode spark.
Check to see if the grill will match light.
Electrode or collector may need adjustment.
3. Venturi may not be properly seated.
4. Venturi may be obstructed.
5. The cylinder valve may be closed.
6. Regulator is not properly seated on cylinder valve.
• Fire at control knobs 1. Venturi is obstructed. See section on
Cleaning and Maintenance of the Venturi.
2. Venturi is improperly seated on control valve.
3. Gas connections may be loose.
Leak Check and tighten all connections.
• Yellow Flames at burner 1. Venturi is obstructed. See section on
Cleaning and Maintenance of the Venturi.
• Flame blows out on "LOW" 1. Venturi may be obstructed. See section on
Cleaning and Maintenance of the Venturi.
2. Grill is not sufficiently preheated.
3. Venturi is improperly seated on control valve.
• Burner does not get hot enough 1. Flow control device has been activated in regulator.
2. Turn off the grill and the fuel supply. Disconnect the
grill from the cylinder valve. Reconnect the grill to
the cylinder and light grill. See section on
Connection to the LP Cylinder.
• Grill is Too Hot 1. Excess grease build-up causing grease fires.
2. Damaged or faulty regulator.
Replace with factory authorized parts.
3. Cook on a lower temperature setting.
15