Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
10
Mobile Installation - Portable LP Gas/
Propane
Recommended minimum LPG cylinder capacity for use with this
appliance is 4kg. Maximum LPG cylinder capacity for use with this
appliance is 10kg. In the USA, only a 20lb cylinder may be used.
Fit the regulator to the LPG cylinder, as shown on the right.
Secure all joints spanner (wrench) tight but do not over-tighten.
For POL cylinders, tighten
counter-clockwise
For Quick Connect cylinders,
tighten clockwise
Before You Begin
If you have not done so already, check the gas type label as described on page 2.
This appliance must have a minimum clearance from combustible materials of all sides
of the barbecue of 450 mm.
Do not install the appliance under or on any combustible surface.
The appliance must be tested for safe and proper operation on completion of
installation.
Keep ventilation openings in the lower cabinet clear and free of any debris.
This barbecue is not approved for use on marine craft.
Fixed Installation - Portable LP Gas/Propane.
BeefEater propane barbecues are designed to operate at 2.75Kpa (11”WC). .
Connect the gas supply line to the barbecue inlet located on the right side of the appliance using either hard
plaumbing, or a flexible hose connected to a bayonet point. Refer to AS 5601 or your local installation code for
pipe sizing details. Secure all joints spanner tight but do not over-tighten.
Test gas pressure by removing the last burner from the left hand side of the barbecue and attaching a hose
and pressure gauge to the end of the gas valve. Turn on 2 burners and check the pressure. Inlet pressure
should be 11.0” WC or 2.75 kPa.
For mobile trolley installations that use flexible hosing to connect to natural gas, a chain or similar restraining
device must be fitted to prevent strain on the gas supply line. One end of the chain should attach to the
barbecue; the other end should attach to a fixed structural point close to where the hose connects to the
gas piping. The chain must be at least 30% shorter than the gas supply line. In this way, if the barbecue is
accidentally moved, the chain stops the barbecue from stretching the hose.
Installation