Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
9
Supplies Needed for a Leak Test:
• Clean paint brush • Water • Dish washing liquid • Empty clean bowl or can for solution
1. Make sure the regulator knob is turned to the “Off” position and verify that the LP Gas Cylinder is tightened
securely to the regulator.
2. Mix one part of water with one part of dish washing liquid.
3. Brush mix on Regulator, Propane Cylinder and connection as indicated by the heavy arrows in the figure below
. If “growing” bubbles appear, there is a gas leak.
a. If leak appears at the regulator/cylinder connection, repeat cylinder installation procedure, but do not over-
tighten. (NOTE: Only hand tighten) Repeat Leak Test.
b. If the leak is coming from the Gas Cylinder or if the leak cannot be stopped, remove the cylinder and DO NOT
USE THE GRILL. Call Customer Service at 1-800-251-7558. Be sure to have the grill model number and
serial number printed on the label, located on the inside of the rear leg. If you need a replacement part
under warranty, a proof of purchase will be necessary.
How to Perform A Leak Test - “FIRST TIME USE”
and as recommended on previous page