Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
10
1. Open the Hood.
2. Push the Regulator Knob in and turn 270 degrees (or 3/4 turn) counterclockwise to the High position (Fig. 2). Note
the triangular indicator mark on the silver regulator housing.
3. Push the Igniter Button in repeatedly until the Burner is lit. Listen for the click indicating spark ignition, and look to
make sure the Burner is lit.
If the Burner goes out during operation, turn Regulator Knob to the “Off” position. Open Hood and wait five minutes
before attempting to relight the grill to allow any accumulated gas to dissipate.
If Burner fails to light after three to four attempts, turn Regulator Knob to the “Off” position and allow any accumulated
gas to dissipate. Check for igniter spark by pushing igniter button and looking at the igniter tip. If no spark, adjust gap
between electrode tip and burner to 3/16” (Fig. 3). If still no spark, see Troubleshooting Section.
Wait five minutes; then repeat the lighting procedures.
The Burner can also be lit manually, see Manual Lighting of the Grill on next page.
Should you notice that your Burner is getting hard to light or the flame is not as hot as it once was, refer to the “How
to Clean your Burner” to remove any possible obstructions.
Lighting Grill Using the Pulse-Spark Ignitor
Lighting the Grill
To reduce the risk of serious bodily injury or death from fire or explosion:
• Open Hood before lighting the grill to release trapped gas.
• During failed lighting attempts, or if the Burner goes out during operation, turn Control Knob “Off” to dissipate
any accumulated gas. Wait five minutes before repeating lighting procedure.
WARNING
!
3/16” gap
If no spark, adjust gap between
electrode tip and burner to 3/16”
Fig. 3
Regulator Control Knob
in OFF position
Fig. 2
Regulator Control Knob
in LOW position
Regulator Control Knob
in HIGH position
Triangular Indicator Mark