321 Studios P777 Gas Grill User Manual


  Open as PDF
of 16
 
E-5
English
Interconnect cables
We recommend the use of high-quality screened cables
that are designed for the particular application. Other
cables will have dierent impedance characteristics
that will degrade the performance of your system (for
example, do not use cabling intended for video use to
carry audio signals). All cables should be kept as short as
is practically possible.
It is good practice when connecting your equipment to
make sure that the mains power-supply cabling is kept
as far away as possible from your audio cables. Failure to
do so may result in unwanted noise in the audio signals.
220V
- 240V
POWER INLET
50Ð60Hz
1800VA
MAX
12V TRIGGER
IN
BALANCED
XLR INPUT
CH.7 / SBR
AUDIO
OUT
IN
4Ð16
OHMS
+Ð
CLASS 2
WIRING
PUSH
INPUT
SELECT
XLR
RCA
BALANCED
XLR INPUT
CH.6 / SR
AUDIO
OUT
IN
4Ð16
OHMS
+Ð
CLASS 2
WIRING
PUSH
INPUT
SELECT
XLR
RCA
BALANCED
XLR INPUT
CH.5 / RIGHT
AUDIO
OUT
IN
4Ð16
OHMS
+Ð
CLASS 2
WIRING
PUSH
INPUT
SELECT
XLR
RCA
BALANCED
XLR INPUT
CH.4 / CENTRE
AUDIO
OUT
IN
4Ð16
OHMS
+Ð
CLASS 2
WIRING
PUSH
INPUT
SELECT
XLR
RCA
BALANCED
XLR INPUT
CH.3 / LEFT
AUDIO
OUT
IN
4Ð16
OHMS
+Ð
CLASS 2
WIRING
PUSH
INPUT
SELECT
XLR
RCA
BALANCED
XLR INPUT
CH.2 / SL
AUDIO
OUT
IN
4Ð16
OHMS
+Ð
CLASS 2
WIRING
PUSH
INPUT
SELECT
XLR
RCA
2
3
1
XLR CONNECTIONS:
PIN1: CABLE SCREEN
PIN2: ÔHOTÕ SIGNAL
PIN3: ÔCOLDÕ SIGNAL
BALANCED
XLR INPUT
CH.1 / SBL
AUDIO
OUT
IN
4Ð16
OHMS
+Ð
CLASS 2
WIRING
PUSH
INPUT
SELECT
XLR
RCA
XLR audio input
Balanced XLR connectors for each
of seven channels, from an XLR-
equipped pre-amplier.
Power inlet
Check the mains
supply voltage matches
the values printed on
the back panel before
connecting the mains
cable here.
12V Trigger input
See page 4 for details.
Speaker terminals
e P777 is equipped with seven pairs of
speaker terminals. See page 7 for information
on the dierent ways of connecting
loudspeakers.
Audio input and output
AUDIO IN from a pre-amplier for each of
seven channels. AUDIO OUT may be used to
bi-amplify a set of speakers (see page 7).
Input select switch
Depress this switch to take the audio source
from the BALANCED XLR INPUT connector for
each channel; if the switch is not depressed,
the audio source is taken from the AUDIO IN
RCA (phono) connector.
 previous next