Weber Weber Liquid Propane Gas Gas Grill User Manual


 
B-7
Check that all burner valves are off
You will need: burner control knobs.
Valves are shipped in the OFF position, but you should
check to be sure that they are turned OFF. Put the
knob on each valve. Check by pushing down and
turning clockwise. If they do not turn, they are off.
Proceed to the next step. If they do turn continue
turning them clockwise until they stop, then they are
off. Proceed to the next step.
Connect filled liquid propane cylinder
ƽ WARNING: Make sure that the cylinder valve is
closed. Close by turning clockwise.
Hook the liquid propane cylinder onto the fuel gauge.
Loosen the cylinder lock wing nut. Swing the cylinder
lock down. Tighten the wing nut.
Checking the fuel level in your tank
Check the fuel level by viewing the color indicator level
line on the side of the tank scale.
1) Empty
2) Medium
3) Full
(1)
(2)
(3)
Remove plastic dust cover from the fuel cylinder valve.
Screw the regulator coupling onto the cylinder
valve(1), clockwise, or to the right. Hand tighten only.
Note: This is a new type of connection. It tightens
clockwise and will not allow gas to flow unless the
connection is tight. The connection requires tightening
by hand only.
ƽ WARNING: Do not use a wrench to tighten the
connection. Using a wrench could damage the
regulator coupling and could cause a gas leak.
Regulator vent hole should be at 3, 6, or 9 oclock. It
should not be pointed up.(2)
(1)