Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
5
BUILT-IN SIDE BURNER
For Summit Natural
Gas Cooking Modules
THIS ACCESSORY MAY BE PURCHASED SEPERATELY.
GENERAL INFORMATION
BUILT-IN CONSTRUCTION GENERAL INFORMATION
WARNING
A Weber-Stephen Products Co. insulated sleeve must be used for any built-in installation.
CLEARANCE FROM COMBUSTIBLE SURFACES OR
STRUCTURES
Warning: Clearance from the outside walls of the sides and
back of the sleeve must be a minimum of 24 inches from a
combustible surface. Measure from the outside wall of the
sleeve to the combustible surface. Figure 2. Refer to “Install
Gas Supply” on page 2 before starting installation.
Figure 2
Figure 1
CLEARANCE FROM NON-COMBUSTIBLE SURFACES OR
STRUCTURES
Warning: Clearance from the outside walls of the sides and
back of the sleeve must be a minimum of 6 inches from a
non-combustible surface. Measure from the outside wall of
the sleeve to the non-combustible surface. Figure 1. Refer to
“Install Gas Supply” on page 2 before starting installation.
COMBUSTIBLE SURFACE
24 inches
24 inches
24 inches
NON- COMBUSTIBLE SURFACE
6 inches
6 inches
6 inches
WARNING: All countertop finished surfaces must be
constructed of a noncombustible material.
WARNING: All countertop finished surfaces must be
constructed of a noncombustible material.
Countertop
Countertop
Insulated sleeve
Insulated sleeve
LOCATING YOUR SIDE BURNER
When determining a suitable location for your side burner installation, give attention to concerns such as exposure to wind, proximity
to traffic paths, and keeping any gas supply lines as short as possible. Never locate the Weber Gas Side Burner in a garage,
breezeway, shed, under an unprotected overhang, or other enclosed area. Locate the side burner and structure so there is enough
room to safely evacuate the area in case of a fire.
THIS GAS APPLIANCE IS DESIGNED
FOR OUTDOOR USE ONLY.